Home
>
07-24
/ 2023
1. Avoid overcharging the battery in the UPS power supply. Because overcharging is easy to cause the bending of the positive and negative plates inside the battery and the active material on the surface of the plates to fall off. When the consequences are light, the available capacity of the battery will decrease, and in severe cases, the battery will be damaged. the
06-26
/ 2023
The battery is mainly composed of positive plate, negative plate, separator, battery shell, cover, lead nail, positive pole, negative pole, rubber cap and electrolyte.
11-07
/ 2022
The length of the service life of the car battery depends on the structure and quality of the battery on the one hand, and is closely related to the daily maintenance on the other hand.The following aspects are what we need to pay attention to.
10-21
/ 2022
The performance of UPS batteries is very superior. In normal times, you should maintain a suitable ambient temperature, charge and discharge them regularly, and replace spent/bad batteries in time. The following mainly shares the characteristics of UPS batteries.
10-17
/ 2022
The glass fiber separator used in the AGM sealed lead battery has a porosity of 90%, and sulfuric acid is adsorbed in it, and the battery adopts a tight assembly form, so the diffusion and electromigration of ions in the separator are very little hindered, so the AGM sealed lead battery has Low internal resistance, high current and fast discharge capability.
10-14
/ 2022
AGM sealed lead-acid battery uses pure sulfuric acid aqueous solution as electrolyte, and its density is 1.29-1.3lg/cm3. Except for a part of the electrolyte absorbed inside the plate, most of it exists in the glass fiber membrane. In order to provide a channel for the oxygen precipitated from the positive electrode to the negative electrode, it is necessary to keep 10% of the pores of the separator that is not occupied by the electrolyte, that is, a lean liquid design. In order to make the electrode plate fully contact the electrolyte, the electrode group adopts the method of tight assembly.